User Manual BB1/070/1
Page 4 of 12
3 Preparations before use
3.1 Mounting of the Wheels
Lay down the unit carefully on its side.
Be careful not to damage the side walls.
Note that the lockable wheels shall be
mounted on the long legs.
Use the enclosed Allen key and tighten hard!
Be careful not to damage the paint.
Raise the unit to an upright position
3.2 Side Walls
If sidewalls are not mounted then please see
section Service.
Raise the sidewalls gently and slide them into
place and remove the protection film.
3.3 Tent pole, Tent and Mattress
Mount the tent pole in the rear bracket.
The Tent has a channel inside. Thread the Tent pole into the channel in order to secure it.
Place the mattress in the bed.
3.4 Check all bolts and screws
Make sure that all bolts and screws are properly tightened and that the bed
feels stable. Run the electrical bed up and down and ensure that it moves smoothly without
any unusual noise.
3.5 Kanmed Babywarmer
The Kanmed Babywarmer control unit is hung on its bracket under the bed.
The heating pad cable is preferably thread through one of the holes in the bed and connected to the
control unit. The Kanmed Babywarmer is connected to mains power by its own cable.
3.6 First cleaning
The unit is factory clean but must be cleaned according to your hospital routines.
Please refer to section maintenance for cleaning before use with the first patient.
