User Manual
BW-50-070/10
Page 6 of 16
Control Unit
The Control Unit can be connected to all existing mains power supply voltages (observe fuse change) and
frequencies or be battery powered from 12 - 24 Volts. See technical section.
The handle is designed so that the control unit can be safely hung on the edge of the bed or on the bed
frame.
Front Panel
1.
Indicators, not
selectable
temperatures
2.
Button for temperature
selection
3. Indicators,
selectable
temperatures
4.
Button for setting temperatures
outside the 35 - 37
O
C range
5.
Indicator for Mains power
6.
Indicator for battery power
7.
Alarm indicators
8.
On /Off, Start button
9.
Silence alarm button
Rear Panel
1.
Earth potential
connection
stud
2. Mains
voltage
indicator
3. Fuse
holder
4.
Locker for
fuse
holder
5. Heating
Pad
connector
6. Mains
switch
7. Mains
socket
8.
Connector for
external 12/24V battery
The Heating Pad
Avoid bending the Heating Pad.
The design and construction of the Heating Pad has reduced magnetic and electrical fields to normal
background levels and thereby making them harmless.
The voltage to the Heating Pad is SELV (24V DC, Safe Extra Low Voltage).
See technical data for information about warming up times.
Explanation of the drawings on the Heating Pad
Please make them available while reading this
1.
Heating Pad BW-50-002 may only be connected to Control Unit BW-50.
2.
Never place a baby or a child directly on the Heating Pad.
3.
The Heating Pad must be inserted in the pocket under the Water Mattress.
4.
The correct amount of water is obtained by filling the Water Mattress to the level mark.
5.
The Heating Pad must be inserted into the pocket of the Water Mattress with its illustrations facing
the Water Mattress. This is best done if the Water Mattress is placed upside down on a flat surface.
6.
The Heating Pad and the Water Mattress shall not be exposed to sharp objects.
7.
For cleaning and disinfecting see user’s manual.
8.
The Heating Pad must be stored flat or rolled with a diameter of at least 10 cm (4"). Do not fold
