22
13
13
13
13----5 Adjusting the spreaders
5 Adjusting the spreaders
5 Adjusting the spreaders
5 Adjusting the spreaders
The clearance between spreader K
，
L and M and needles should be 1~1.2mm.
Spreader up-and-down adjustment is made with screws Q.
Spreader tilt adjustment is made with screws R.
【
14
】
PTV MECHANISM
14
14
14
14----1 Disassembling and reassembling the binder
1 Disassembling and reassembling the binder
1 Disassembling and reassembling the binder
1 Disassembling and reassembling the binder
■
To disassemble the binder
Remove screw A. Remove the binder by pulling it
toward you while referring to arrows B and C.
■
To reassemble the binder
Fit the ends of upper fabric guides (F) onto lower
fabric guides (G). Move the binder down in the
direction of arrow H. Check that end D of the
screw touches the bracket. Then tighten screw A.
< Note >
When removing the binder, be careful not to damage
the ends of the fabric guides.
