4-2 Installing the machine
Install the brackets on the underside of the table board (see the illustration below).
Fit the rubber cushions onto the brackets.
Mount the machine head on the rubber cushions.
【
5
】
TIMING OF THE LOOPER TO THE NEEDLES
5-1 Angle and height for installing the looper
To obtain the proper angle and height,
insert the looper fully into looper holder A
and then tighten screw B.
The proper angle for the looper on HDX is
5°. Distance at 20mm from the point of
the looper between the bottom of the looper
blade and the extension line from the point
of the looper : Approximately 1.75mm.
5
H
H
D
D
X
X
s
s
e
e
r
r
i
i
e
e
s
s