4
<
Note
>
After adjusting, drop down upper cutter at the bottom
position ( bottom dead point ).
Then, confirm whether upper cutter and lower cusster
shall meet each other at 1 mm distance or not.
<
Note
>
When checking the proper overlapping between upper
cutter and lower cutter, move upper cutter by your
hand.
【
5
】
ADJUSTMENT (AIR TYPE)
5555----1 Height of Cutter
1 Height of Cutter
1 Height of Cutter
1 Height of Cutter
Loosen screw K and adjust lever L in order to set
24 mm of the distance between lower cutter and
upper cutter at the top position (top dead point).
5555----2 Overlapping of Cutter
2 Overlapping of Cutter
2 Overlapping of Cutter
2 Overlapping of Cutter
1. Loosen screw M, then loosen screw N until
disappearing of pressurized power of upper
cutter.
2. Loosen screw O, then adjust screw P in order
to overlap properly between upper cutter and
lower cutter.
5555----3 Power of Upper Cutter
3 Power of Upper Cutter
3 Power of Upper Cutter
3 Power of Upper Cutter
After loosen screw M, then adjust the pressurized
power of upper cutter against lower cutter by screw
N.