15
10
10
10
10----4 Position of the needle thread guard
4 Position of the needle thread guard
4 Position of the needle thread guard
4 Position of the needle thread guard
When the needle bar is at the bottom of its stroke,
the center of the eyelet of thread guide A should be
level with the top surface of needle thread guard B.
In addition, A should be parallel with B.
To adjust the height of needle thread guard B,
loosen screw C and move needle thread guard B up
or down.
To tighten the needle thread, move up B.
To loosen the needle thread, move down B.
■
For cotton threads (non-stretchable threads)
Bring the needle thread guard 2.0mm below the
standard, or remove it. Loosen screw C and move
down the needle thread guard.
■
For woolly threads (stretchable threads)
Raise the needle thread guard as high as possible.
10
10
10
10----5 Posi
5 Posi
5 Posi
5 Position of the thread guide of the spreader thread take
tion of the thread guide of the spreader thread take
tion of the thread guide of the spreader thread take
tion of the thread guide of the spreader thread take----up
up
up
up
When the needle bar is at the top of its stroke,
thread any one of parts A, B and C on the spreader
thread take-up with the spreader thread.
■
For woolly threads: Thread B or C.
■
For cotton threads or spun threads
Thread A and adjust the spreader thread take-up
according to the thread or fabric to be used.
Adjust by moving up or down the spreader thread
take-up with screws D.
10
10
10
10----6 Position of the thread guide of the looper thread take
6 Position of the thread guide of the looper thread take
6 Position of the thread guide of the looper thread take
6 Position of the thread guide of the looper thread take----up
up
up
up
The eyelets on thread guides B and C should be
aligned with mark X on thread guide A.
To increase the amount of the looper thread
supplied by the looper thread take-up, loosen screws
of thread guides B and C and move the thread
guides to the front. To decrease it, move the thread
guides to the back. Adjust according to the thread
and stitch length to be used.
For woolly threads, move thread guides B and C to
the front. Do not thread the tension disk.
