3
Ｍ
Ｍ
Ｍ
Ｍ
Ｍ
Ｍ
Ｍ
Ｍ
Ａ
Ａ
Ａ
Ａ
Ａ
Ａ
Ａ
Ａ
Ｃ
Ｃ
Ｃ
Ｃ
Ｃ
Ｃ
Ｃ
Ｃ
1
1
1
1
1
1
1
1
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
【
3
】
LUBRICATION
3333----1 Oil
1 Oil
1 Oil
1 Oil
Use Kansai Special’s genuine oil
(Part No. 28-611)
3333----2 To fill the machine with oil
2 To fill the machine with oil
2 To fill the machine with oil
2 To fill the machine with oil
Remove oil plug A. Fill the machine with oil until
the oil level is at the top line (see H in the
illustration) on oil gauge C.
After the first lubrication, add oil so that the oil
level will be between H and L.
After filling the machine with oil, tighten plug A
and run the machine to check the oil is splashing
from oil pipe outlet B.
3333----3 Replacing the oil and the filter element
3 Replacing the oil and the filter element
3 Replacing the oil and the filter element
3 Replacing the oil and the filter element
To extend machine life, be sure to replace the oil after the first 250 hours of operation.
To replace the oil, follow the procedures below.
1. Remove the V belt from the motor pulley and then remove the machine from the
table.
2. Remove screw D and then drain the oil.
Be careful not to stain V belt with the oil.
3. After draining the oil, be sure to tighten screw D.
4. Fill the machine with oil by referring to 3-2 shown above.
If filter element E is contaminated, proper oiling may not be performed.
Clean the filter element every six months. If just a little or no oil flows out from the
nozzle with the proper amount of oil in the machine, check the filter element.
To clean the filter element, remove oil reservoir.
