12 of 35
KP2230 User Manual Version 1.0-EN
OPERATING MODE
The scanner can be configured to work in:
•
Wireless Mode: In this mode the data read will be sent immediately to computer
•
Storage Mode: In this mode the data will be saved in the internal memory of the device
To configure the operating mode follow the below settings:
Wireless Operating
In wireless mode the data is transmitted directly to the computer through the 2.4GHz integrated Radio. After the successful
transmission the device will emit a low frequency short tone and the blue light will flash.
If there is failure on transmission the barcode will be lost.
To set wireless mode scan the code
Wireless mode
Storage Mode
This mode can be used when the device is out of the wireless transmission range.
In storage mode the data is stored in the internal memory of the device. After reading the barcode the device will make a short
sound (low frequency and high frequency) while the blue light will flash.
When the storage memory is full, the device will issue 6 high frequency beep.
Up to 50.000 character can be saved into the storage memory.
To configure the scanner in Storage operating mode scan the below code
Enable Storage Mode
