MICRO REMOTE
8
potting material to damage
internal electronic components.
The main power to the receiver
should be connected through a
switched, fused line capable of a
minimum of 100 amps. For best
results, connect power (+) to
the motor driver via an auxiliary
terminal of the ignition switch,
PTO switch, or ignition relay.
Connecting the ground (-)
directly to the BATTERY –
terminal is preferred for optimal
performance.
All connections must be properly
insulated to protect against
shorts.
Seal all connections with a non-
conductive silicone grease to
prevent corrosion.
BEFORE APPLYING
POWER!
Check power and ground for
proper polarity.
Check the wiring harness for
possible
shorts
before
connecting to output devices
(i.e., valves and relays) by
checking each mating pin
terminal.
Verify that the transmitter
battery is fully charged.
Read the rest of this manual.
