Risk of Injury or damage to machine!!
NEVER OPERATE THE UNIT IF IT BEGINS TO VIBRATE!
Shutdown the unit and tighten the rotating bar, bolts and fittings.
PRE-START INSPECTION PROCEDURES:
1. Inspect Rotary Surface Cleaner before each use. Tighten rotating bar,
bolts and fittings as needed.
2. Ensure all connections are secure. Turn the water supply completely
"ON". (DO NOT START PRESSURE WASHER!)
3. Inspect hoses for kinking, cut or leaks. If found, DO NOT USE HOSE!
Replace damaged hoses before starting.
4. Unlock the trigger gun and squeeze the trigger. Water will begin
flowing from the nozzles of the Surface Cleaner. Ensure nozzles are
not clogged and spray pattern is not erratic. Change nozzles before
proceeding if problems exist.
5. Be sure that all damaged parts are replaced and that the mechanical
problems are corrected prior to operation. If you need service, contact
an Authorized Service Center.
INSTALLATION & PREPARATION
CLEAN UP WITH YOUR ROTARY SURFACE CLEANER
SPECIAL APPLICATION AREAS:
- Removing deposits, mass, algae, fuel, oil and grease from drive
through pads, boat ramps, tennis courts, roofs, pools, decks ,
walkways, factory floors, semi trailer floors, fishing docks, and
loading docks
- Cleaning off stubborn stains from asphalt and concrete surfaces
- Disinfection for the highest hygiene demands in saunas, bathroom
areas, and in the catering industry.
- Great for cleaning driveways.
BENEFITS OF PRESSURE WASHER SURFACE CLEANERS:
-
Huge time savings
- Easy, effortless work
- Substantially lower cost (especially labor)
- Visibly greater cleanliness
- Universally applicable
- Use with cold or hot water
- Circular design allows a zero wall clearance
- Hover action (cleaner "floats" above the ground)
- Eliminate streaking and fatigue
The following comparison chart
shows the time taken to clean
a typical driveway (37 sq. meter)
Using 2 different components.
Rotary surface cleaner 10 min.
ATTACHMENT
TIME
Standard spray nozzle 80 min.
COMPLETE SET UP
7
