USA
For routine cleaning, your machine is equipped with the following
accessories:
- Spraymaster, drive plate for pads, yellow-and-brown or green
pad for Low-Speed BD44-180 or Spraymaster, drive plate for
pads, red pad for High Speed BD44-450
·
Fill the spray can with the desired product.
·
Fit the drive plate with the desired pad.
·
Start the machine.
·
When you pull the Spraymaster lever a few times the cleaning
agent is sprayed onto the floor. Now start cleaning immediately
until a shine is produced.
·
We advise cleaning the surface in relatively small areas at a time.
The machine is ideal for cleaning with polymer dispersions. The
coating’s resistance to foot traffic and general wear and tear is
preserved. Streaks and marks are easier to remove.
Polishing with BD44-450 / Duo-Speed 380 rpm
For polishing, equip your machine with the following accessories:
- Drive plate for pads, white pad for High Speed BD44-450.
·
Fit the drive plate with the pad.
·
Then start the machine.
Service
·
For repairs, please contact your specialist wholesaler or one of the
service shops.
·
You will be expertly and quickly served.
·
Warning!
This machine is only intended for use on level surfaces
with a maximum gradient of up to 2 %.
·
Warning!
This machine is not approved for use on public paths
and roads.
Servicing instructions
the following instructions must always be observed
·
When cleaning and servicing the machine, replacing parts or when
changing over to a different function, switch off the drive and re-
move the plug.
·
The power supply lead must not be damaged by driving over it,
crushing, tugging etc.
·
Check the power supply lead regularly for signs of damage.
·
The machine must not be used if the power supply lead is not in
perfect condition.
·
When using or replacing the power supply or equipment supply
leads, use only those specified by the manufacturer.
·
When replacing the plug-and-socket connectors of power supply or
equipment supply leads, splash protection and mechanical
strength must be assured.
·
When transporting the machine in lifts, put the shaft/bar in a verti-
cal position so that it cannot catch on the lift walls.
·
The shaft/bar is automatically secured against recoil by the paten-
ted shaft/bar adjustment unit.
·
Only the spray and cleaning agents suitable for the machine’s
purpose may be used.
·
Never use highly flammable, combustible, toxic, health-hazardous,
corrosive or irritant substances.
·
Repairs, including the fitting of spray agent lines and hoses, may
only be carried out by approved customer service shops or by
specialists in this field who are familiar with all the relevant safety
regulations.
Storage
When the machine is not being used, store it in a dry place and in
normal room conditions (not below under 0
°
C).
Technical specifications
BD44-180
BD44-450
BD - Duo-Speed
A.C. motor
115 V: 60 Hz
115 V; 60 Hz
115 V; 60 Hz
Rated power
750 – 1200 W
1500 – 1800 W
750 – 1500 W
4 – 7,5 A
5,5 – 8A
5,5 – 8,5 A
Brush (rpm)
180
450
190 / 380
Brush (mm)
430
430
430
Working height (mm)
117
117
117
Working weight
33 kg
33 kg
35,5 kg
Protection class
l
l
I
Belt-driven
x
x
x
Subject to technical change
