Operating Instructions
English
38
Attach bearing cover.
Tighten the wing nuts.
Replacing disc brushes
Raise the disc brushes.
Rotate disc brushes by approx. 45° in an
anti-clockwise direction.
Pull down and remove disc brushes.
Insert the new disc brushes in reverse
sequence.
Maintenance agreement
To ensure that the unit operates reliably,
maintenance agreements can be
concluded with the appropriate Kärcher
sales office.
Frost protection
If there is a risk of frost
Drain the fresh-water and dirty-water
tanks.
Put the unit in a room which is protected
from frost.
Transportation
Risk of injury!
The unit may be loaded and
unloaded on max. 10 % inclines only.
If transporting the unit by vehicle, secure
the unit with tension belts/ropes to
prevent it from sliding.
Raise the cleaning head to prevent
damage to the brushes.
BD Trike
Remove the disc brushes from the brush
head.
Troubleshooting
Risk of injury!
Before working on the appliance,
always set the key switch to “
O
”, remove
the key and disconnect the mains plug from
the battery charger.
Drain off and dispose of dirty water and
any residual cleaning liquid.
If faults cannot be rectified with the aid of
this table, contact customer service.
Changing the fuses
The drive control/electronics module is
attached under the front panel. If a fuse has
to be changed, this front panel must be
removed.
Loosen the screws on the housing.
Change the fuse.
Re-attach the front panel.
Information:
The fuse configuration is indicated on
the inside of the front panel.
!
!
i
Summary of Contents for BD Trike BAT
Page 26: ...Operating Instructions English 26 Operating and function controls ...
Page 496: ......
Page 497: ......
Page 498: ......
