Kärcher BDS 43/Orbital C Spray, Instructions Manual

English

11

Operation

Adjusting the handle

몇

WARNING

Danger of accident

If the handle is adjusted while the mo-
tor is running, the device may perform 
uncontrolled movements.
Only adjust the handle when the de-
vice is switched off.
1. Pull the tilt adjustment lever up-

wards and hold it.

2. Move the handle to a comfortable 

position (approximately hip height).

3. Release the tilt adjustment lever.
4. Gently move the handle up and 

down until it locks into place.

Switching the device on

몇

WARNING

Danger of injury

Without ground friction, the pad can 
assume very high speeds. It can fly 
away and cause injuries.
Do not switch on the device when the 
cleaning head is swiveled up.

The maximum permissible grid im-
pedance at the electrical connection 
point (see Technical data) must not 
be exceeded. 

Contact your electricity supplier in the 
case of any uncertainties regarding the 
mains grid impedance at your electrical 
connection point.

ATTENTION

Risk of damage

If the device is operated in one spot for 
a long time, the floor covering may be-
come damaged.
Always move the device while it is 
switched on.
1. Unwind the power cord completely 

from the cable clips.

2. Insert the mains plug into an outlet.

3. Hold the handle with both hands.
4. Press and hold the unlocking button.
5. Operate the ON/OFF switch.
6. Release the unlocking button.
7. To interrupt operation, release the 

ON/OFF switch.

Cleaning

1. Switch the device on.
2. Pull the cleaning solution lever when 

the pad is to be supplied with clean-
ing solution.

3. Guide the device over the surface to 

be cleaned.

4. In case of heavy contamination, go 

over the affected area several times.

5. Afterwards, vacuum the waste water 

with a wet vacuum cleaner or soak it 
up with a cloth.

Spray system

Only the BDS 43/Orbital C Spray is 
equipped with the spray system. On 
this system, cleaning solution is ap-
plied from two nozzles in front of the 
device.
1. Set the Spray switch to the "ON" po-

sition.

Adjust the nozzles

1. Release the clamping screw.
2. Align the nozzle.
3. Tighten the clamping screw.

Shutting down

1. Pull the mains plug out of the outlet.
2. Pull the tilt adjustment lever up-

wards and hold it.

3. Move the handle to a vertical posi-

tion.

4. Release the tilt adjustment lever.
5. Remove the remaining cleaning 

solution from the detergent tank.

6. Rinse the detergent tank with clean 

water.