Kärcher BDS 43/Orbital C Spray, Instructions Manual

12

English

7.

BDS 43/Orbital C Spray only:

Rinse the spray system with clean 
water.

8. Wind the power cord around the ca-

ble hooks.

9. Swivel the cleaning head upwards 

by lifting it by the handle.

Illustration O

1

Handle

2

Cleaning head

10.Remove the pad from the pad drive 

board.

11.Clean the device with a damp cloth.

Transport

몇

CAUTION

Failure to observe the weight

Risk of injury and damage
Be aware of the weight of the device 
during transportation.
1. Pull the tilt adjustment lever and po-

sition the handle vertically.

2. Release the tilt adjustment lever.
3. Tilt the device backwards and go to 

the destination.

4. Secure the device in accordance 

with the respective applicable guide-
lines to prevent it from slipping or 
overturning when in transport.

Storage

몇

CAUTION

Failure to observe the weight

Risk of injury and damage
Be aware of the weight of the device 
during transport and storage.
1. Store the device indoors only. 
2. To protect the pad, swivel the clean-

ing head upwards by lifting it by the 
handle.

Illustration O

1

Handle

2

Cleaning head

Care and service

몇

WARNING

Danger of injury

The device may start up unexpectedly.
Make sure the mains plug is removed 
from the socket before starting any 
work on the device.
1. Wash dirty pads at a maximum tem-

perature of 60°C.

2. Clean the casing of the device with a 

damp cloth and then rub dry.

3. Check the power cord for damage.

Troubleshooting guide

몇

WARNING

Danger of injury

The device may start up unexpectedly.
Make sure the mains plug is removed 
from the socket before starting any 
work on the device.
In the event of malfunctions that can-
not be remedied using the following in-
formation, please contact Customer 
Service.

Unsatisfactory cleaning result



Replacing a dirty pad.



Renewing a worn pad.



Check the suitability of the detergent 
used for the application.



Check the suitability of the pad used 
for the application.

The device vibrates strongly



Check that the pad is positioned 
centrally on the pad drive board.



Check the attachment of the pad.

The pad does not rotate



Check whether any foreign objects 
are blocking the pad drive board. 
Remove any foreign objects if nec-
essary.



Plug the mains plug into the socket.