background image

13

English

(with or without detergent)

. Pre-rinse furniture

and surrounding area with fresh water. If using 
detergent, apply to surface at low pressure. Allow
detergent to remain on surface 1-3 minutes. Do
not allow detergent to dry on surface. If needed
use special Wash Brush Attachment (not 
included) to remove stubborn dirt. Rinse at high 
pressure in a sweeping motion keeping the spray
nozzle approximately 3-6 inches from the clean-
ing surface. For best results, clean from top to 
bottom and from left to right.
         

CAUTION

Do not use Dirtblaster spray nozzle on patio or
lawn furniture as it may cause damage.

        CAUTION

Before cleaning any surface an inconspicu-

 

ous area should be cleaned to test spray 
pattern and distance for maximum cleaning 
results.
If painted surfaces are peeling or chipping, 

 

use extreme caution as pressure washer 
may remove the loose paint from the 
surface.
When using on surfaces which might come 

 

in contact with food, flush surfaces with 
plenty of drinking water.
For additional cleaning tips and a complete-

 

video library, visit our website:

        www.karcherresidential.com

Optional accessories are available to further 
enhance your cleaning capabilities. Please check 
our website for pricing and
up-to-date information.

(with or without detergent)

. Pre-rinse cleaning

surface with fresh water. If using detergent or 
Degreaser, apply to surface at low pressure. 
For best results, limit your work area to smaller 
sections of approximately 25 square feet. Allow 
detergent or Degreaser to remain on surface 
1-3 minutes. Do not allow detergent to dry on 
surface. Rinse at high pressure in a sweeping 
motion keeping the spray nozzle approximately 
3-6 inches from the cleaning surface. Always 
clean from top to bottom and from left to right. 
For removing extremely stubborn stains, use the 
Dirtblaster® Nozzle.

(with or without detergent)

. Pre-rinse vehicle

with fresh water. If using detergent, apply to sur-
face at low pressure. For best results, clean one
side of vehicle at a time and always apply deter-
gent from bottom to top, do not allow detergent 
to dry on surface. If needed, use special wash 
brush attachment (not included) to remove stub-
born dirt. Rinse at high pressure in a sweeping 
motion keeping the spray nozzle approximately 
6-8 inches from the cleaning surface (distance 
should increase when rinsing pin-striping or 
other sensitive surfaces). Always clean from top 
to bottom and from left to right. For best results, 
wipe surface dry with a chamois or soft dry cloth.
         

CAUTION

Do not use Dirtblaster spray nozzle on vehicles
as it may cause damage.

(with or without detergent)

. Pre-rinse cleaning

surface with fresh water. If using detergent or De-
greaser, apply detergent at low pressure. Allow
detergent to remain on surface 1-3 minutes. Do
not allow detergent to dry on surface. Rinse at
high pressure keeping the spray nozzle approxi-
mately 3-6 inches from the cleaning surface. For
removing extremely stubborn dirt, it may be nec-
essary to move the spray nozzle even closer to
the surface for greater dirt cutting action.
         
        

CAUTION

Do not use Dirtblaster spray nozzle on cloth,
plastic or other sensitive surfaces as it may
cause damage.

Cement Patios, Brick and Stone

Cars, Boats & Motorcycles

Barbecue Grills, Outdoor Power 

Equipment & Gardening 

Patio & Lawn Furniture

Optional Accessories

Summary of Contents for G 2600 PC
















Reviews: