Kärcher HD 10/21-4 Cage, Manual

– 3

Notes about the ingredients (REACH)

You will find current information about the 
ingredients at: 

www.kaercher.com/REACH

– Check the contents of the pack before 

unpacking. 

– In case of transport damage inform ven-

dor immediately.



Read the oil level display when the de-
vice is not running. The oil level must be 
between the two markers on the oil res-
ervoir.



Cut off tip of oil container cover

Note:

 The EASY!Lock system joins com-

ponents with a quick-fasten thread solidly 
and securely with just one turn.



Insert the high pressure nozzle onto the 
spray lance.



Install union nut and hand-tighten it 
(EASY!Lock).



Join the spray lance with the trigger gun 
and tighten until hand-tight 
(EASY!Lock).



Join the high-pressure hose with trigger 
gun and high-pressure connection of 
the appliance and tighten until hand-
tight (EASY!Lock).

몇

WARNING

Risk of injury! Appliance, accessories, sup-
ply lines and connections must be in fault-
free condition. If they are not in a perfect 
state then the appliance must not be used.

몇

DANGER

Danger of injury by electric shock.

–

It is imperative to connect the appliance 
to the electric mains by means of a plug. 
It is forbidden to permanently connect 
the appliance to the power supply. The 
plug serves for the disconnection from 
the mains.

–

The appliance may only be connected 
to alternating current.

–

Minimum fuse strength of the socket 
(see Technical Data).

–

The highest allowed net impedance at 
the electrical connection point (refer to 
technical data) is not to be exceeded. In 
case of confusion regarding the power 
impedance present on your connection, 
please contact your utilities provider.

–

Use the extension cord that has an ad-
equate cross-section (see "Technical 
Data") and unwind it fully from the cable 
drum.

For connection values, see type plate/tech-
nical data.

몇

WARNING

Observe regulations of water supplier.

For connection values refer to technical 
specifications.



Connect the supply hose (minimum 
length 7.5 m, minimum diameter 3/4“) to 
the water connection point of the ma-
chine and at the water supply point (for 
e.g. a tap). 

Note:

The supply hose is not included.



Open the water supply.

Before Startup

Unpacking

Check oil level

Activate deaeration of oil container

Attaching the Accessories

2.

1.

Start up

Electrical connection

Water connection

Connection to the water supply

13

EN