English
7
Use the top or bottom steam switch.
–
Steaming at intervals:
Press the
steam switch. Steam will be emitted
while the switch is pressed.
–
Continuous steaming
: Pull the latch
for the steam switch toward the rear un-
til it locks in. Steam will escape continu-
ously. To unlock, push the lock forward.
Direct the first burst of steam at the start
of the ironing process or after ironing
breaks at a separate piece of cloth until
the steam is emitted evenly.
You can hold the iron in an upright posi-
tion to apply steam to curtains, dresses,
etc.
Adjust the temperature of the iron ac-
cording to the garment you want to iron.
Note:
Please observe the ironing and
washing instructions in your garment
.
As soon as the indicator lamp of the
heater of the iron switches off, you can
start ironing.
Often, failures have simple causes and you
can do the troubleshooting yourself using
the following overview. If you are in doubt
or if the failure is not listed here please con-
tact the authorized customer service.
Danger
Always disconnect the mains plug and al-
low the steam cleaner to cool down before
performing any maintenance work.
Repair works may only be performed by the
authorized customer service.
Set the thermostat to level •••.
Rinse or decalcify the boiler of the
steam cleaner.
During longer breaks from ironing, the
steam in the steam line can condense.
Direct the first burst of steam at a sepa-
rate piece of cloth.
Subject to technical modifications!
Dry ironing
•
Synthetics
•• Wool, silk
••• Cotton, linen
Troubleshooting
No steam
Steam iron "spits out" water!
After breaks during ironing, water drops
will come out of the steam pressure iron.
Technical specifications
Electrical connection
Voltage
220 V
1~50 Hz
Protective class
I
Performance data
Heating output
650 W
