14
English
몇
Warning
Do not use a forklift truck to unload the ma-
chine as this may damage it.
To unload the machine, proceed as follows:
Î
Cut plastic packing belt and remove foil.
Î
Remove the elastic tape fasteners at
the stop points.
Î
Remove the front wheel lock.
Î
Freewheel lever for moving the appli-
ance without adjusting self-drive (see
below).
Î
Drive the device forward from the pal-
ette.
Î
Tilt the suction head upward.
Î
Close the waste container lid.
Î
Pull the waste container backwards out
of the device.
Î
Connect the black earthing cable to the
battery and tighten the clamp screw.
Î
Insert the waste container into the appli-
ance.
Î
Open the waste container lid.
Î
Tilt down the suction head.
Î
Freewheel lever for moving the appli-
ance without adjusting self-drive (see
below).
The machine can be moved in 2 ways:
(1) By pushing it (see device without engag-
ing self-propulsion).
(2) By driving it (see device by engaging
self-propulsion).
Danger
Risk of injury! Before engaging the free-
wheel operation, the machine must be se-
cured to prevent it rolling away.
Î
Open the device hood and secure it us-
ing the hood support.
1
Freewheel lever
Î
Press the red freewheel lever down-
wards, then move it to the left and lock
it in.
This blocks the travel drive function.
Î
Close cover.
The machine can now be pushed.
Note
Do not move the machine for long distances
without engaging self-propulsion, a speed
of 6 km/h should not be exceeded.
Î
Press the freewheel lever downwards,
then move it to the right and lock it in.
The travel drive is now ready for operation.
Î
Close cover.
The appliance can now be driven.
Note
The attachment sets mentioned here are
not part of standard delivery of the device
and need to be ordered separately accord-
ing to requirements.
The attachment sets not listed here have
their own separate assembling instructions.
The steering roller is attached to the front
end of the suction pipe.
Î
Move the fastening clip of the steering
roller over the suction pipe.
Î
Align steering roller and close quick-
snap.
Î
Park the machine on an even surface.
Î
Remove ignition key.
Danger
Risk of explosion!
–
Only use the fuels specified in the Oper-
ations Manual.
–
Do not refuel the machine in enclosed
spaces.
–
Smoking and naked flames are strictly
prohibited.
–
Ensure that no fuel reaches the hot
open surfaces.
–
Use only those cans that have been ap-
proved for fuel.
Î
Switch off engine.
Î
Open the device hood and secure it us-
ing the hood support.
Î
Open fuel filler cap.
Î
Use "regular unleaded petrol".
Î
Fill tank to max. 2.5 cm below the upper
edge of the filler nozzle.
Î
Wipe off any spilt fuel and close fuel fill-
er cap.
Î
Close cover.
Î
Check engine oil level. *
Î
Check fill level of fuel tank.
Î
Check hydraulics fluid fill level. *
Î
Empty the waste container.
Î
Check tyre pressure. *
* For description, see section on Care and
maintenance.
You need the garbage bag accessory kit if
the vacuumed material is to be collected in
a garbage bag.
Î
Tilt the suction head upward.
1
Sleeve
2
Garbage bag, 240 litres
Î
Place the cover down on the floor with
the holder loops.
Î
Push the garbage sack over the cover.
Î
Turn the cover along with the garbage
back and insert it into the garbage con-
tainer with the shorter side at the rear.
Î
Place the upper edge of the garbage
sack around the edge of the garbage
container.
Î
Tilt down the suction head.
Danger
Long hours of using the appliance can
cause circulation problems in the hands on
account of vibrations.
It is not possible to specify a generally valid
operation time, since this depends on sev-
eral factors:
–
Proneness to blood circulation deficien-
cies (cold, numb fingers).
–
Low ambient temperature. Wear warm
gloves to protect hands.
–
A firm grip impedes blood circulation.
–
Continuous operation is worse than an
operation interrupted by pauses.
In case of regular, long-term operation of
the device and in case of repeated occur-
rence of the symptoms (e.g. cold, numb fin-
gers) please consult a physician.
Before Commissioning
Unloading
Device without engaging self-pro-
pulsion
Moving device by engaging self-
propulsion
Install attachment sets
Attacchment set: Steering roller
Start up
General notes
Refuelling
Inspection and maintenance work
Insert the garbage sack (only with
the garbage sack accessory kit)
Operation
Summary of Contents for IC 15/240 W
Page 1: ...Deutsch 3 English 12 IC 15 240 W 5 962 627 0 2018690 08 07...
Page 2: ...2...
Page 21: ......