Kärcher K 3.95 M Instructions Manual Download

Page: 10 / 172

Deutsch

that a distance of at least 30 cm is observed
when cleaning with the jet!

Never draw in fluids containing solvents or
undiluted acids and solvents! This includes
petrol, paint thinner and heating oil. The
spray mist thus generated is highly inflam-
mable, explosive and poisonous. Do not use
acetone, undiluted acids and solvents as
they are damaging to the materials from
which the appliance is made.

몇

Warning

The mains plug and the coupling of an exten-
sion cable must be watertight and must nev-
er lay in the water.

Unsuitable extension cables can be hazard-
ous. Only use extension cables outdoors
which have been approved for this purpose
and labelled with a sufficient cable cross-
section: 1 - 10 m: 1.5 mm

; 10 - 30 m: 2.5

Always fully unroll electrical cables from the
cable drum.

High-pressure hoses, fixtures and couplings
are important for the safety of the appliance.
Only use high-pressure hoses, fixtures and
couplings recommended by the manufacturer.

This appliance is not intended for use by per-
sons with reduced physical, sensory or men-
tal capabilities.
The appliance must not be operated by chil-
dren or persons who have not been instruct-
ed accordingly.
Children should be supervised to prevent
them from playing with the appliance.

The operator must use the appliance correct-
ly. When working with the appliance, he must
consider the local conditions and pay due
care and attention to other persons, in partic-
ular children, who are nearby.

Do not use the appliance when there are oth-
er persons around unless they are also wear-
ing safety equipment.

Wear protective clothing and safety goggles
to protect against splash back containing wa-
ter or dirt.

Caution

In case of extended downtimes, switch the
appliance off at the main switch / appliance
switch or remove the mains plug.

Do not operate the appliance at tempera-
tures below 0 °C.

Observe a distance of at least 30 cm when
using the jet to clean painted surfaces to
avoid damaging paintwork.

Never leave the appliance unattended when
it is in operation.

Make sure that the power cable or extension
cables are not damaged by running over,
pinching, dragging or similar. Protect the
power cable from heat, oil, and sharp edges.

All current-conducting parts in the working
area must be protected against jet water.

The appliance may only be connected to an
electrical supply which has been installed in
accordance with IEC 60364.

The appliance may only be connected to al-
ternating current. The voltage must corre-
spond with the type plate on the appliance.

The maximum tolerable mains impedance at
the electrical contact point (see Technical
Data) must not be exceeded.

For safety reasons, we recommend that you
operate the appliance only via a earth-leak-
age circuit breaker (max. 30 mA).

Cleaning operations which produce oily
waste water, e.g. engine washes, underbody
washes, may only be carried out using wash-
ing stations equipped with an oil separator.

This appliance was designed to be used with
detergents which are supplied or recom-
mended by the manufacturer. The use of oth-
er detergents or chemicals may compromise
the safety of the appliance.

Caution

Safety devices protect the user and must not be
modified or bypassed.

The appliance switch prevents unintentional op-
eration of the appliance.

This lock locks the lever of the trigger gun and
prevents the inadvertent start of the appliance.

The overflow valve prevents the permissible
working pressure from being exceeded.
If the lever on the trigger gun is released the
pressure switch turns off the pump, the high-
pressure jet ist stopped. If the lever is pulled the
pump is turned on again.

Safety Devices

Power switch

Lock trigger gun

Overflow valve with pressure switch

English