13
4.3 Low Pressure Operation with Brush
When cleaning surfaces with a grease contamination - typically car
paintwork that always has a greasy traffic film covering. Follow the
procedure of:
Washing loose dirt away with the clean water high pressure spray.
Apply the detergent in low pressure mode by removing the bayonet
fit spray lance and fitting the Washing Brush (No.7c) to the Spray
Gun.
Leave for 2-4 minutes for the detergent to have maximum effect.
With or without the pressure washer switched on, brush down the
surface being cleaned, this physical agitation removes all trace of
traffic film.
Finally revert to the high pressure operation with the Spray Lance
and complete the wash down.
We recommend the following cleaning method:
Step 1:
Remove loose dirt by washing over the surface to be cleaned with the
high pressure jet.
Step 2:
Spray on the detergent and leave for 1-4 minutes, so assisting the easy
removal of fine dirt and associated greasy adhesions.
Step 3:
Finally, spray off the loosened dirt with the high pressure spray.
4.4 End Of Operation
ALWAYS REMEMBER TO RINSE YOUR PRESSURE WASHER
AFTER USING DETERGENT BY HANGING THE DETERGENT
SUCTION TUBE IN A CONTAINER WITH CLEAN WATER AND
RUN THE PUMP FOR APPROXIMATELY ONE MINUTE IN LOW
PRESSURE SETTING.
Summary of Contents for KB 2020
Page 21: ...21 10 ASSEMBLY High Pressure Hose No 8 and Spray Gun No 10 Assembly ...
Page 23: ...23 Notes ...
Page 24: ......
