Operating instructions
KM 100/100 R / KM 100/100 R P
English
29
!
Slide the new main brush into the
main brush box and slip it onto
the drive peg
Notes:
—
Pay attention to the position of
the bristle set when installing the
new main brush!
—
The bowden cable is to be
adjusted so that the main brush
is raised approx.
1
0 mm from the
floor.
!
Follow the instructions in reverse
to mount the main brush rocker
arm
!
Screw on side panelling
!
Insert the swept material
container
Adjusting and replacing
sealing strips
!
Stand sweeper on a flat surface
!
Raise the sweep roller
!
Turn key switch to "0" and
remove key
!
Secure the machine against
rolling away using a wedge
!
Remove the debris container
from both sides of the unit
!
Screw off side panelling on both
sides
!
Unscrew front screw of side
panelling
!
Unscrew rear screws of side
panelling
Front sealing strip
!
Slightly loosen fastening nut at
the front sealing strip, unscrew it
to replace it
!
Screw on new sealing strip but
do not yet tighten nuts
!
Align the sealing strip
!
Set the sealing strip’s clearance
to the floor so that it bends
backwards with a lag of
35 - 40 mm
!
Tighten nuts
Rear sealing strip
!
The floor clearance of the sealing
strip is set so that it bends
backward with a lag of
5 -
1
0 mm
!
Replace if worn
!
Dismantle the sweeping drum
!
Unscrew fastening nuts of the
rear sealing strip
!
Screw on new sealing strip
Side sealing strips
!
Slightly loosen fastening nuts of
the side sealing strip, unscrew
them to replace it
!
Screw on new sealing strip but
do not yet tighten nuts
!
In order to set the clearance to
the floor slide in the
1
- 2 mm
spacer
!
Align the sealing strip
!
Tighten nuts
!
Screw on side panelling
!
Insert the swept material
container
