Operating instructions
KM 100/100 R / KM 100/100 R P
English
24
Empty the swept material
container
!
Wait until automatic filter
dedusting is completed and the
dust has settled before opening
the debris container and
emptying it.
!
Pull out debris container
!
Empty the swept material
container
!
Slide in and lock the debris
container
!
Then perform the same
operations on the opposite debris
container
Usage instructions
Safety instructions when
sweeping
Warning!
—
Never sweep up packing straps,
wires or the like as this could
damage the sweeping
mechanism.
—
When the coarse-dirt flap is
open, the main brush can hurl
stones or stone chips forwards.
Make sure that nobody, no
animals or objects are
endangered.
Notes:
!
For optimum cleaning effect,
match the driving speed to suit
the actual conditions.
!
During operation the debris
container should be emptied at
regular intervals.
!
Lower only the main brush when
sweeping large floor surfaces.
!
Also lower the side brush when
cleaning inner surface edges.
Sweeping dry ground
!
Close the bypass cover on left
behind the seat
Sweeping damp or wet
ground
!
Open the bypass cover on left
behind the seat
—
This protects the filter from damp
Driving over obstacles
Fixed obstacles of up to 50 mm in
height
!
Slowly and carefully drive over
them in the forward direction.
Fixed obstacles over 50 mm in
height
!
May be driven-over only with a
suitable ramp.
Drive system overload
warning
To prevent damage to the drive
system the sweeper is provided with
an overload warning and a shut-off.
—
The overload warning flashes if
the overload of the drive system
reaches a critical stage. The
overload can be sustained for
1
min. , after which the sweeper is
switched off by the control.
—
The control switches the sweeper
off immediately if the drive
system’s overload exceeds the
overload limit.
Resetting
!
Stop machine
!
Turn the key switch to
position "0"
!
Turn the key switch to position "I"
Sweeping system overload
warning
In order to avoid damage to its
sweeping system the sweeper is
provided with an overload warning
and a shut-off.
—
If the load on the sweeping
system reaches the overload limit
the overload warning lights up
and the control switches the
sweeping system off after 4 s.
Resetting
!
Switch off sweeping system
!
Turn the key switch to
position "0"
!
Turn the key switch to position "I"
