-
5
1 Latching tabs
2 Filter cover
3 Filter inlay
Press the locking nose in the direction
of the arrow.
Remove the filter cover.
Take out the filter inlay.
Check filter inlay and clean or replace if
required.
Blow out the filter cartridge from the in-
side using compressed air (max. 2 bar)
or knock it on a hard surface. Do not
brush down.
Carefully clean the filter housing and fil-
ter cover by means of a damp cloth and
ensure that no dirt finds its way into the
carburettor.
Close the filter cover.
DANGER
Risk of burns!
Allow engine to cool down.
Remove spark-plug connector.
Unscrew and clean spark plug.
Screw in cleaned or new spark plug.
Recommended spark plug: see techni-
cal data
Push on spark-plug connector.
1 Fuel cock closed
2 Hose clip
3 Fuel hose
Close fuel cock.
Turn the rotating knob perpendicular to
the fuel tap.
Press together the fuel hose from the
tank to the fuel tap.
Loosen the hose clamp on the fuel tap.
Remove the fuel hose.
Open fuel filler cap.
Hold the fuel hose over a suitable catch
bin and drain the fuel.
If the tank is empty, reattach the fuel
hose to the stub of the fuel tap and in-
stall the hose clamp.
Note
: If the appliance is not used for a
longer period of time, drain the carbu-
rettor too. In order to do so, start the
motor and let it run until it stops due to
a lack of fuel.
Remove belts or cords from roller
brush.
Replacement is due if a visible deteriora-
tion in sweeping performance caused by
bristle wear despite height adjustment of
the roller brush is evident.
Park the sweeper on an even surface.
1 Roller brush
2 Dog plate
3 Dog, roller brush drive
4 Threaded rod
5 Nut
Loosen the nut on the threaded rod and
pull out the rod.
Remove the roller brush halves and re-
place it by new ones.
Note
: Ensure that the recesses of the
roller brush halves point towards the
dog.
Insert the threaded rod and secure it by
means of a nut.
Set the roller brush to the proper height,
using the height adjustment.
Clean or replace filter cartridge
Clean or replace the spark plug
Empty fuel tank
Checking roller brush
Replacing roller brush
14
EN
