KMR 1250 D
User Instructions
English
33
Preparing the sweeper for
use
All directions given (left/right, front/rear) are as seen from
the driver’s seat.
n
Check the oil level in the engine (see Chapter: “Mainte-
nance”).
n
Check the amount of fuel in the tank and fill up, if required
(see below).
n
Check the level of hydraulic fluid and top up, if required
(see Chapter: “Maintenance”).
n
Check the air pressure in the tyres (see Chapter:
“Maintenance”).
n
Inspect the brush roller and remove any string, rope, etc.,
that may be caught up in the brushes.
n
Check the dust filter. If it is very dirty, operate the shaker
to clean it off.
n
Empty the waste container.
Adjusting the driver’s seat
The driver’s seat can be adjusted to suit persons of various
heights.
n
Unhook the rods
1
in the seat tilting device.
ç
Undo the 4 screws.
n
Move the seat to the desired position.
n
Tighten the screws and hook the rods back into the tilting
device.
Filling the fuel tank
!
Explosion hazard while refuelling!
n
Do not fill up with fuel
– in an enclosed space
– while the engine is running.
n
Do not smoke while refuelling the vehicle.
n
Fuel expands as it becomes warmer.
Do not fill the tank right up to the top. Leave a gap of at
least 1 cm under the bottom edge of the filler neck.
n
Wipe up any fuel they may have been spilt and ensure
that the cap is replaced firmly on the tank.
n
Use only diesel.
Open fuel tap
n
Open unit cover
ç
Open fuel tap at position 0 (OPEN)
Lever points downwards
n
Close unit cover
