Kärcher MT 36 Bp Manual Download

Page: 11 / 148

English

●

Continuous operation is more harmful than opera-
tion interrupted by work breaks.

You should see a doctor if using the device regularly
and for lengthy periods of time, and in the event of re-
peated occurrences of symptoms such as tingling in
the fingers or cold fingers.

Intended use

●

The Multi-Tool is suitable for commercial use.

●

The Multi-Tool is intended for use with the pole saw
accessory or with a pole hedge trimmer and a pole
extension.

●

The device is intended for outdoor use only.

●

For safety reasons, always hold the device firmly
with both hands.

Any other use is prohibited. The user shall be liable for
hazards arising as a result of improper use.

Environmental protection

The packing materials can be recycled. Please
dispose of packaging in accordance with the en-
vironmental regulations.
Electrical and electronic appliances contain valu-
able, recyclable materials and often components
such as batteries, rechargeable batteries or oil,
which - if handled or disposed of incorrectly - can

pose a potential threat to human health and the environ-
ment. However, these components are required for the
correct operation of the appliance. Appliances marked
by this symbol are not allowed to be disposed of togeth-
er with the household rubbish.

Notes on the content materials (REACH)

Current information on content materials can be found
at:

www.kaercher.com/REACH

Accessories and spare parts

Only use original accessories and original spare parts.
They ensure that the appliance will run fault-free and
safely.
Information on accessories and spare parts can be
found at

www.kaercher.com

Scope of delivery

The scope of delivery for the appliance is shown on the
packaging. Check the contents for completeness when
unpacking. If any accessories are missing or in the
event of any shipping damage, please notify your deal-
er.

Symbols on the device

Description of the device

The maximum amount of equipment is described in
these operating instructions. Depending on the model
used, there are differences in the scope of delivery (see
packaging).

See graphics page for illustrations
Illustration A

Clamping screw

Lock

Shaft

Front handle

Trigger lockout button

Speed switch

Trigger

Rear handle

Battery pack unlocking button

Eyelet for carrying belt

Type plate

*Battery Pack Battery Power 36V

*Quick Charger Battery Power 36V

Carrying belt

* optional

Rechargeable battery pack

The device can be operated with a 36 V Kärcher Bat-
tery Power+ battery pack.

Installation

Installing the front handle

1. Screw the front handle to the shaft at the desired po-

sition.

Illustration B

Initial startup

Installing accessories

ATTENTION

Dirt at the joints

Damage to the device if dirt gets between the connec-
tion points during assembly.
Check the joints for contamination and remove before
assembly.
Only lay dismantled connecting parts on clean surfaces.

1. Plug in the accessories

Illustration C

a Loosen the clamping screw.
b Pull out the lock.
c Insert the shaft of the accessory.

2. Allow the lock to latch into place. Make sure that the

lock is securely positioned in the hole of the inserted
shaft.

3. Tighten the clamping screw.

Installing the battery pack

1. Push the battery pack into the mounting in the de-

vice until it audibly latches into place.

Illustration D

Hooking the carrying belt

The carrying belt helps to lower the device in a con-
trolled manner after cutting and to catch the weight of
the device during use.
1. Fit the hook of the carrying belt into the eyelet on the

shaft.

Illustration E

General warning symbol

Read the operating instructions and all
safety instructions before operating the
device for the first time.

Pull: Quick-release catch