Kärcher Puzzi 30/4, User Manual

– 4



Connect the manifold (with suction pipe 
and nozzle) to the suction hose.



Connect the coupling of the spray hose 
with the manifold and snap in place.



Fill approx. 0.5 gal (2 litres) of fresh wa-
ter into the fresh water reservoir.

Do not add any detergents.



Set rotary switch to spraying. Spray 
pump is switched on.



Hold floor nozzle over a drain.



Activate lever on bender and flush the 
appliance for appr. 1 to 2 minutes.



Switch off the appliance, in order to do 
so, set the rotary switch to 0/OFF.



Flush appliance.



Dismantle the bonnet, unlock and re-
move the filter casing. Clean the bonnet 
under running water.



Empty the wastewater container and 
clean it under running water.



Empty the fresh water reservoir.



Clean the outside of the appliance with 
a damp cloth.



Remove all water from the appliance 
prior to longer periods of non-use to 
avoid offensive odours.



Allow appliance to dry thoroughly: Un-
lock the bonnet, swivel it upwards and 
snap it in place at the locking devices. 
Remove the lid of the fresh water tank.

Illustration 



Place the floor nozzle in the tray and 
snap the suction pipe into the holder.



Store the suction hose and the mains 
cable as shown in the illustration. 



Place the appliance in a dry room and 
secure it from unauthorized use.



Spray and suction off detergent solution 
in one work cycle.

Note:

 Repeated suctioning without spray-

ing will shorten the drying time.



Apply detergent solution with suction 
turbine turned off and soak for 10 to 15 
minutes.



Clean the surface just like with normal 
soiling.



In order to further improve the cleaning 
result, the surface can be recleaned us-
ing clear, warm water.



Attach hand nozzle (optional accesso-
ry) instead of the floor nozzle.



With sensitive materials, use less deter-
gent and spray the surface at a distance 
of approx. 7.9 in (200 mm). Then simply 
vacuum off.

– Highly soiled spots should be pre-

soaked and the detergent solution 
should soak 5 to 10 minutes.

– Always work from the light to the shade 

(from the window to the door).

– Always work from the cleaned to the un-

cleaned surface.

– The more sensitive the surface (oriental 

rugs, berbers, upholstery material) the 
lower the cleaning solution concentra-
tion should be.

– Rugs with jute backing can shrink if too 

much water is used and can bleed col-
ours.

– Brush high-fiber rugs in the direction of 

the weave after cleaning (using a fiber 
brush or a scrubber).

– Water-proofing the fabric using Care 

Tex RM 762 after the wet cleaning pre-
vents a quick resoiling of the textile sur-
face. 

Flush appliance

After each operation

Storing the Appliance

Cleaning methods

Normal soiling

Strong soiling or stains

Upholstery cleaning

Cleaning tips

11

EN