English
5.906-507.0 Rev. 00 (08/10)
7
Î
Remove the connecting cable from the brush mo-
tor.
Î
Unscrew the fastening screws (2x) for the brush
motor.
Î
Remove the brush motor.
Î
Install the new brush motor in reverse sequence.
1 Brush motor
2 Anti-interference filter
3 Power cord
4 Clamp for mains cable
5 Power switch
6 Safety switch
7 Terminal strip
Î
Remove the clamp for mains cable.
Î
Unscrew the ground cable (protective conductor)
from the terminal strip.
Î
Remove the phase and the zero conductor from
the terminal strip.
Î
Thread the mains cable through the grommet.
Î
Install the new mains cable in reverse sequence.
Î
Remove the connecting cable of the noise filter on
the brush motor and unscrew it from the terminal
strip.
Î
Replace the interference filter.
Î
Connect the new noise filter.
Î
Remove the connecting cable from the appliance
switch/safety switch.
Î
Replace the appliance switch, safety switch.
Î
Connect the appliance switch, safety switch.
1 Brush roller
2 Brush roller cover
3 Fastening screws
Î
Place the PW 30/1 on its back.
Î
Unscrew locking screws.
Î
Remove the brush roller cover plate.
1 Toothed belt cover
2 Fastening screws
Î
Unscrew locking screws.
Î
Remove cover.
5.1.4 Replacing the mains cable
5.1.5 Replace the interference filter
5.1.6 Replace the appliance switch, safety switch
1
4
2
6
3
5
7
5.2
PW 30/1
5.2.1 Replacing the brush roller
