SC 1502
English – 25
• Completely dissolve the contents of one bag
of the Kärcher bio-descaler RM 511 in one litre
of warm water.
• Pour this solution into the boiler and allow it to
react for approximately 8 hours.
Do not
screw the safety lock on the appliance
while you are descaling the boiler. Never use the
steam cleaner as long as there is descaler left in
the boiler.
• Once the descaling is completed, pour the
descaling solution out. A small amount of the
solution will remain in the boiler. Therefore, you
should rinse the boiler two to three times with
cold water to remove any residues of the
descaler.
• Turn the rotary knob (B1) clockwise until the
stop and then counter-clockwise until the
maximum steam quantity.
• Now, the steam cleaner is ready for use again.
Care of the cloths
Allow the accessory parts to dry completely
before storing them.
• Do not place the floor nozzle (H1), the manual
nozzle (E1), and the round brush (D3) onto the
bristles during the cooling and drying process
to avoid a deformation of the bristles.
The floorcloth and the terry cloth cover have
been pre-washed and can be used immediately
for working with the steam cleaner.
• You can wash dirty floorcloths and terry cloth
covers in the washingmachine at 60°C. Do not
use a liquid softener as this would affect the
ability of the cloths to pick up dirt. You can
tumble dry the cloths as needed.
7. Troubleshooting
Faults often have simple causes which you can
rectify yourself with the aid of the following sum-
mary. In case of doubt or of faults or remedies
not mentioned here apply to the authorized cu-
stomer service.
!
Danger of electric shock!
Repair work on the unit can only be carried out
by the authorized customer service.
Long heating-up time
• Modular accessory plug is not properly
connected
• Boiler is furred
Low steam / no steam
(ready for use indicator lamp is green)
• Check the steam adjustment of the
appliance / steam gun
Steam decreases during the work / no
steam (low water / signal sounds)
• No more water in the water reservoir
- Refill water
Steam switch cannot be pressed anymore
• Release the steam switch lock (C3)
High water discharge during the ironing
• Set the temperature controller of the iron to
the steam range
6. Care & maintenance
Summary of Contents for SC 1502
Page 1: ......
