9
Operations
Make sure that the speed control knob is completely
upright. Turn on the machine by pushing the switch to
the “ON” position.
After approximately five seconds press and hold the
red starter button until you hear the machine ignite,
then release.
Turn the speed control knob to “10” until detergent
appears at the brush head. Then turn the knob to “0”
Let the boiler heat the detergent for about 60 seconds
before continuing.
Turn the speed control knob to number three and wait
until the brush starts to steam. The unit will take about
10 seconds to heat up.
The speed control knob will adjust the amount of fluid
that is dispensed. The speed control knob can be
adjusted depending on the surface type.
Charging the Machine
Plug the charger into the charging port on the
machine.
It will take approximately 4 hours for the battery to
fully charge.
A fully charged battery will last for 8 hours.
Charger will show a red light while charging and a
green light when fully charged.
If charger displays anything other that the listed
colors, contact Kärcher North America.
8.638-519.0 - Operators Manual SG1 C BP
Summary of Contents for SG1 C BP
