– 6
Outdoor surfaces should be swept be-
fore the T-Racer is used to avoid dam-
aging the high-pressure nozzles.
Prior to use on sensitive surfaces (e.g.
wooden surfaces), test the product on
an imperceptible spot, in order to
promptly detect any changes in the sur-
face.
The T-Racer is not suited for scouring
or scrubbing!
Caution
Illustration
Do not run over protruding corners!
Fasten the T-Racer directly to the high-
pressure gun.
1 Press the bayonet connection of the T-
Racer into the connection of the high-
pressure gun, then turn by 90° until it
locks into place.
2 Tighten the safety cover.
Adjust the turning handle "power" as
per the surface to be cleaned
Caution
Illustration
Always hold the T-Racer at the handle
while cleaning the walls.
The turning handle "power" is used to
change the distance of the high-pressure
nozzles to the surface to be cleaned.
Robust surfaces
(for e.g. tiles, concrete,
stone)
Illustration
Set turning handle "power" to "MAX".
For the effective cleaning of hard-to-re-
move contamination.
Sensitive surfaces
(for e.g. wood)
Illustration
Set turning handle "power" to "MIN".
For the gentle cleaning of sensitive sur-
faces.
Illustration
For normal surface cleaning, press the
foot pedal for surface cleaning.
A water stream will be emitted from the
two high-pressure nozzles in the rotor
arm.
Illustration
For edge and corner cleaning, press the
foot pedal for edge cleaning.
A water stream will be emitted from
green high-pressure nozzle.
You can use the extension pipes with any
other Kärcher accessory.
High-pressure cleaner does not build up
the pressure or is vibrating
.
Dismantle the high-pressure nozzles,
check the high-pressure nozzles for
damage, rinse the T-Racer with clean
water then reinstall the high-pressure
nozzles.
Tips for cleaning
Cleaning wall surfaces
Control elements
"Power" turning handle
Foot pedal for surface cleaning
Foot pedal for edge cleaning
Tip
Troubleshooting
9
EN
