Kärcher WRP 1000 comfort Manual Download

Page: 12 / 76

1 F1 Fuse Controls
2 F2 Fuse Motor filament filter
3 F3 Fuse Motor multiport valve

Order No. 5.033-239.0

Order No. 2.641-521.0
Manual switching between processed/
fresh water for using fresh water in the
high-pressure cleaner (for e.g. for rinsing).

Order No. 4.640-230.0

Order No. 6.474-073.0

Order No. 2.641-510.0

Notice

The equipment may only be installed by an

–

mechanic of Kärcher

–

or an from Kärcher authorized individual

The following requirements are necessary
in order to install the equipment:

–

frost-free room with adequate ventila-
tion and exhausts

–

Floor path for collecting sludge

–

Strong wall for fastening the system

–

For electrical connection refer to techni-
cal specifications.

Unpack the equpiment and dispose of the
packing material properly.

The water installation depends on the spe-
cific conditions of the existing plant compo-
nents such as

–

Type and model of high pressure cleaner

Note

The processed water outlet of the system is
directly connected to the water inlet of the
high-pressure cleaner. This can lead to
foam formation in the swimmer tank in
high-pressure cleaners with a swimmer
tank. In such a case, the high-pressure
cleaner must be switched to suction opera-
tioins (see separate operating instructions
of the high-pressure cleaner).

–

Type and models of building-side compo-
nents (sludge collector, pump basin, etc.)

–

Nominal widtht, lengths and type of
channels

Hence, the water installation must be done
according to the specific local conditions.
The immersion pump specifications in the
building must meet the requirements out-
line in the "Technical Data / Immersion
Pump Requirements" section.



Danger

Risk of injury on account of tripping and falling.
Lay the hoses of the plant in such a way
that they do not pose a risk for tripping and
falling.

몇

Warning

–

The appliance may only be connected
to alternating current.

–

The appliance may only be connected
to an electrical supply which has been
installed in accordance with IEC 60364.

–

The voltage indicated on the type plate
must correspond to the voltage of the
electrical source.

–

The appliance should always be con-
nected to the electrical mains using a
plug. It is forbidden to permanently con-
nect the appliance to the power supply.
The plug is only for mains separation.

For connection values, see type plate/tech-
nical data.

We hereby declare that the machine de-
scribed below complies with the relevant
basic safety and health requirements of the
EU Directives, both in its basic design and
construction as well as in the version put
into circulation by us. This declaration shall
cease to be valid if the machine is modified
without our prior approval.

The undersigned act on behalf and under
the power of attorney of the company man-
agement.

Authorised Documentation Representative
S. Reiser

Alfred Kärcher GmbH Co. KG
Alfred-Kärcher-Str. 28 - 40
71364 Winnenden (Germany)
Phone: +49 7195 14-0
Fax: +49 7195 14-2212

Winnenden, 2010/11/01

Fuses

Accessories

Filter inlay

Attachment set 'Fresh water switching'

Attachment set input valve

Upgrade kit - submersion pump

Attachment kit ventilation

Installing the unit (only for