English
29
1
High-pressure cleaner
2
Pressure control
3
Pressure gauge
4
Oil filler opening
1. The high-pressure cleaner is intended for use as a hot
water high-pressure cleaner for the elimination of weeds
and as a cold water high-pressure cleaner for cleaning
regions that are difficult to access.
2. The water jet is applied using a high-pressure gun with
spray lance and a corresponding nozzle attachment.
3. Weed elimination can also be performed over larger ar-
eas using an optional front bar. Contact Kärcher for
more information.
14.2 Control panel
The work temperature can be preselected at the thermo-
stat.
The burner does not switch on until the blower switch is
switched on.
1
Thermostat (electronic / buttons
˄˅
short press = 1 °
steps, long press = 5 ° steps)
2
Burner blower on/off switch
3
Battery malfunction indicator
4
Warning light: cleaning container or fuel tank empty
Note
When the warning light comes on, the burner switches off
1. Set the thermostat to 105 °C and switch on the blower
(burner) for weed control.
Switch off the blower switch immediately on completion
of work to prevent the battery from being drained.
2. For cold water high-pressure cleaning, set the thermo-
stat to 25 °C and switch off the blower (burner).
14.3 Battery
The WRS 200 is equipped with an integrated battery that
is charged by an alternator.
The battery is required for starting the burner.
1
Battery
2
Minus terminal
1. Please consult the operating instructions of the carrier
vehicle for information on care, maintenance and safe
handling of batteries.
2. When storing the device for longer than 1 month, dis-
connect the minus terminal of the battery and recharge
the battery every 2 months.
14.4 Eliminating weeds
Vehicle settings:
The procedure varies from vehicle to vehicle. Please refer
to the operating instructions of the vehicle used for the ex-
act procedure.
●
PTO 40 litres/min
●
Engine speed at least:
–
MIC 35/42: 2250 rpm
–
MIC 50/70: 2100 rpm
–
MC 130: 2400 rpm
–
MC 250: 1200 rpm
●
Deactivate the seat contact switch (when working with
the standard high-pressure gun and spray lance acces-
sories).
WRS 200 settings (hot water operation):
●
Switch on the blower (burner).
●
Adjust the temperature on the thermostat using SET
and the
˄˅
buttons. Confirm with
√
(setting range
+25 °C to +105 °C, temperature dev/- 5 °C).
Note
The burner will now heat up automatically to the set tem-
perature (see heating symbol in the display). When the
temperature is reached, the burner switches off (heating
symbol in the display goes out). If the deviation falls below
5 °C, the burner switches on again and regulates up to
max. 105 °C. The set temperature is stored and retrieved
in the operation (in case work is interrupted during the
working day).
●
Fit the desired accessory (optional) to the spray lance.
●
Adjust the pressure control at the spray lance or at the
high-pressure pump as required.
