English
5
Illustration
Insert the charger delivered with the ap-
pliance into a proper socket.
Insert the charging cable plug to the
back of the appliance.
Note
: During the charging process, the
charge/operating display blinks. Once
the battery is fully charged, it will be per-
manently illuminated.
Recharge the battery after finishing
your work.
Illustration
Press the spray lever on the bottle to
apply the detergent and spray the sur-
face evenly; after that, loosen the dirt
using the wiping pad.
Note
: Rinse pad under running water if
needed!
Illustration
Switch the appliance on, the charge/op-
erations display will illuminate.
Pull the appliance from the top to the
bottom to vacuum up the detergent.
Note
: Hard to reach areas can be vacu-
umed vertically or horizontally (limited
areas).
Notes:
If the battery is losing its performance, the
charge/operations display will begin to blink
slowly and the appliance will shut off after a
certain time. In this case, recharge the bat-
tery.
Switch the appliance off after each cleaned
surface. This will increase your operating
time per battery charge.
Apply the detergent as usual according
to manufacturer's instructions and loos-
en the dirt.
Further procedure same as the "Clean-
ing with spray bottle and wiper attach-
ment", see illustration
.
Illustration
Set the appliance on the support leg
(parking position) and switch it off.
Once the max. fill level (mark) of the dirt
water reservoir is reached, please empty
the tank.
Turn off the appliance.
Illustration
Pull off the lock of the dirt water reser-
voir and empty the tank.
Close the dirt water reservoir.
Charge the battery
Start working
Cleaning with spray bottle and wiper at-
tachment
Cleaning without the spray bottle
Interrupting the work
Emptying the reservoir during oper-
ation
