EVM Modules of the MS Series Technical Introduction and User’s Guide
33
Erasing A Single Message:
An ACD message that has been entered before can be erased by this
program.
8644M
86440M
(For EVM224S and EVM128S)
Parameters:
M
: Two-digit message number (in the range 00 ... 23)
Notes:
1.
This program can be entered only through the operator phone while the
system is in programming mode.
2.
The dual-frequency tone is received during the erasing operation and
when the operation is over, the internal dial tone is received.
3.
The operator must take the ACD service off line before entering that
program.
Ring Count Time-Out For DISA/ACD Lines:
By this program, the time-out period is set, after which a call coming over
the DISA/ACD lines is to ring on the operator or the ringing extension.
Following that period, the call is automatically connected to the operator or
the ringing extension.
80823 P
Parameters:
P
: 10..99
Ring count time-out in seconds
Default value:
P=15
PDF created with pdfFactory Pro trial version
