EVM Modules of the MS Series Technical Introduction and User’s Guide
13
INSTALLATION
EVM38S:
Installation of EVM38S starts with the mounting of the plastic box of the
module on the wall. For this:
1)
Front cover of the EVM38S plastic box is opened by pressing the small
holes on the side faces with a screwdriver or with a similar tool that is
thin, but with a dull point, and by pulling the cover toward front at the
same time.
2)
The location where the module will be mounted is determined by making
use of the mounting template that comes with the module and the screw
spots are marked. (A location close to the exchange should be chosen
for the installation by taking the length of the EVM38S connection cable
into consideration, while this operation is being fulfilled).
3)
The anchor plugs are driven into the wall at the marked spots without
deviating from the actual points.
4)
The screws are so driven to leave 7mm-portion of their heads out of the
wall. (Heights of the screw heads can be checked by the edge of the
mounting template).
5)
The module is hung by letting the screw heads pass through the pear
holes at the back cover of it.
6)
The front cover of the module is replaced after the cable connection is
completed.
Important note
:
If the EVM38S module will operate together with MS38S
R40Ga or an exchange of an earlier version, then the EVM38S converter
cable must be used.
The free and of the cable of the exchange, whose wall mounting has been
completed, is connected to the EVM connector of the exchange, and the
system setup becomes complete.
The exchange must be off during that operation.
PDF created with pdfFactory Pro trial version
