6
EXTERNAL RELAY CONNECTION
A relay is available on the motherboard for controlling several external devices. That
relay is capable of allowing 2 A current over 250 VAC / -24 VDC. By this relay, it is
possible to control a door opener, an external music source, the external
announcement system or an external ringer, according to the way the system is
programmed. Connection to the external relay is made through the 2-pin connector
(the leftmost two pins of the 4-pin music / external relay connector) that is on the
MS48IP
motherboard. Which one of the devices mentioned above the relay is to be
employed for controlling is determined by programming.
EXP48IP VOIP MODULE
The EXP48IP VoIP Module is a card which can be installed directly on the system
motherboard or any of the analog expansion cards. It functions as the IP server of the
system as well as the Caller ID module of the system. The module is mainly formed up
of two cards:
1) EXP48IP Media Gateway Card
2) EXP48IP Mainboard
The two cards are connected to each other to form the VoIP module.
The EXP48IP VoIP module has the following functional blocks:
·
Microprocessor and the memory elements used for the IP functionality of the
system.
·
An ethernet switch
·
FSK receiver (4 channels)
·
FSK generator (8 channels)
·
IP extensions
·
IP trunks
·
IP Media Gateway (MGW – AC494 series DSP circuit)
The EXP48IP Mainboard also has an SO-DIMM type connector which is used to install
DSP expansion card on the system.
Summary of Contents for MS48IP
