62
⚫
Positioning supports should not be used for occupant
restraint in a moving vehicle unless they are labeled as
being in accordance with the requirements specified in ISO
7176/19-2008.
⚫
A manufacturer’s representative should inspect the
wheelchair before reuse following any vehicle-related
incidents.
Note
The positioning belt of the wheelchair must always be used in
addition to, not as a substitute for, the three-point belt restraint.
11.2 Transporting the wheelchair without occupant
To fold or unfold the wheelchair, refer to
or
11.2.1 Lifting the wheelchair
Always lift the wheelchair by grabbing the frame at the points shown in the
picture.
Lifting the wheelchair
Lifting the folded wheelchair
Summary of Contents for Flexx Adapt
Page 1: ...User manual Flexx Adapt...
Page 2: ......
Page 50: ...44 1 Loosen the screw D 2 Move the lower strap to the desired position 3 Tighten the screw D D...
Page 79: ......