23
SUGGESTION:
●
Please transfer to a seat in the car if at all possible
4.14.1 Before Use
4.14.1.1 Please detach all easily removable accessories from the wheel-chair
and stow them in a safe place where they cannot move around and
become a safety hazard.
4.14.1.2 A four point tie-down system should tightly fasten to
the lower wheelchair frame marked with a yellow
sticker as pictured at the right.
4.14.1.3 An occupant restraint system using both a pelvis and harness must
also be fastened to the transport vehicle to insure user safety.
Please refer to the restraint system's instructions.
4.14.1.4 The attendant / transporter must double-check all fastening points
for proper connection and tightness to assure the wheelchair users
safety. The attendant / transporter must fully understand the
fastening system's usage and its weight limitations.
4.14.1.5 Please see http://www.unwin-safety.com/ for more information.
4.14.2 Method of Restraint
The KM-1500F14 was tested with four point webbing systems, with the
back in the upright position. Please refer to the restraint
manufacturer's user guide for further details of its operation.
4.14.2.1 Fitting the front restraint
- Connect the straps around the wheelchair frame and castor bracket
as pictured below. The anchor point is marked with a yellow sticker.
- Take the brakes off and reverse the wheelchair to tension the front
straps. Apply wheelchair brakes (the brakes should be left on during
transport)
4.14.2.2 Fitting the rear restraint
Summary of Contents for KM-1000 Series
Page 1: ...Manual Wheelchair Owner s Manual KM 1000 Series KM 1000 KM 1500 KM 1510...
Page 2: ......
Page 43: ......