24
4.12 Rear Wheel Disassembly
Quick release rear wheels are optional. If your wheelchair is equipped with
quick release rear wheels, please follow these instructions as listed below.
4.12.1 Ensure that the brake is in the unlocked position first.
4.12.2 Support the weight of the chair with one hand by holding the push
handle.
4.12.3 Press the hub cover and pull out the rear wheel.
4.12.4 Remove the rear wheel. (See Figure 4.64)
4.13 Rear Wheel Assembly
4.13.1 First ensure that the brake is in the OFF position.
4.13.2 Take up the wheel with axle and press the hub cover in the center of
the axle, as above.
4.13.3 This retracts the ball bearings that will allow you to push the axle into
the wheel bracket that is located on the lower rear frame of the
wheelchair.
4.13.4 When you remove your thumb from the button on the axle, the ball
bearings should be visible protruding from the axle at the back of the
wheel bracket. This will secure the wheel safely in the frame. (See Figure
4.65)
Figure 4.64
Figure 4.65
Summary of Contents for VIP2 Series
Page 1: ...Manual Wheelchair Owner s Manual VIP2 Series VIP 2 T VIP2 TR...
Page 2: ......
Page 51: ......
Page 52: ...110400000688 Rev 02 2018 04...