17
4. Shipping Brace
A shipping brace has been used to secure the saw frame to the saw base. Do not remove this
brace until the machine is properly installed.
5. Machine Placement and Position
The followings should be considered when positioning the machine:
The floor:
The machine should be placed on a levelled concrete floor.
Working area:
Sufficient space should be allocated around the machine for comfortably
loading and unloading work stock and for easy access during maintenance and repair. When
necessary, all doors and access panels should be opened without interference.
Lighting:
The machine and its surroundings should be well lit for operator’s safety and for a
convenient operation and maintenance.
Leveling:
Once the machine has been positioned on the floor, it must be leveled. Adjust the
leveling screws so that the machine is leveled on a horizontal plane in two directions; side-to-
side and front-to-back within a tolerance of 0.1/1000 mm. Use vise bed surface to place the
machinist's level. All of the four leveling screws should be supporting the machine. After
leveling, make sure that the nuts are tightened if the stud bolts are used. Leveling is very
important to obtain consistent and accurate cuts.
Note:
After leveling, the shipping brace should be removed from the saw.
Leveling Bolt
Floor Seating Plate
Ground Stud Bolt and
Ground Anchor Plug
Summary of Contents for KMT 400 KSA
