23
10-
Turn on the main switch of the machine.
11-
Turn the hand-wheel to right (to tensioning position) to apply a
light pressure
.
12-
Press the back edge of the blade fırmly against the flange of each band wheel.
13-
Turn the hand-wheel to right (tensioning position) to exert sufficient tension on the
saw blade.
14-
Turn off the main switch of the machine.
15-
Turn the knurled knobs clockwise to tighten the carbide pressure pads against the
blade. Tighten the carbide guides by hand only.
Note:
Do not over-tighten the carbide pressure guides.
16-
Adjust the position of the chip brush so that the bristles reach fully into the gullet of
the blade without extending beyond. Then lock the chip brush in place.
Important:
Improper positioning of the chip brush will result in excessive blade or chip
brush wear.
17-
Make sure that you close and secure the band wheel covers and blade guards at the
end of this process.
Summary of Contents for KMT 400 KSA
