16
Note: Apply blue thread lock to all screws, balls, and threads which it be
fixed to metal-parts. For non-metal parts apply CA Glue.
Step in assembly BEVEL PINION GEAR clearly more above
can see in Tips & Information at www.kasama.com
After Main Gear is inserted you can adjust bevel gear up and down 1mm. by turning the Bevel
Gear Adjuster clockwise to raise the bevel gear and anti-clockwise to lower it.
1)
Raise the bevel gear to its highest position by turning the Adjuster clockwise – lock bevel
gear block in place by tightening the two M3x32 bolts.
2)
Loosen Lower Bearing Block bolts and push block down to allow Main crown Gear to sit on
Bevel Gear.
3)
Loosen Center bearing Block bolts and push it down to sit on top of One Way Bearing then
tighten M3x32 bolts firmly.
4)
Loosen Lower Bearing Block M3 bolts and push Block up till it rests on the bottom of the
OWB and tighten bolts.
5)
Test Main Gear end-float by pulling Main Shaft up and down.
6)
If there is no end-float tighten Lower and Center Bearing Block mounting bolts firmly – if
there is movement of gear and mast repeat steps 2-4.
7)
Loosen Bevel Gear Block M3 bolts and rotate Adjuster until Bevel Gear has ~0.3-0.5 mm.
backlash on Main Gear. You can also ‘tune it’ by ear by spinning main gear till you get the
smoothest and quietest sound of the gears running.
BEVEL PINION GEAR ADJUSTMENT
CLUTCH BEARING BLOCK INSTALLATION
9
CCW = Down 0.5 mm (Approximately)
Zero point
CW = Up 0.5 mm (Approximately)
WARNING
