10 TABLE FAN
SOLVENTS OR ABRASIVE DETERGENTS.
•THE APPLIANCE IS DESIGNED FOR DOMESTIC USE.
CAUTION!
FAILURE TO COMPLY WITH THE WARNINGS CONTAINED IN
THIS MANUAL AND IMPROPER USE OF THE ARTICLE MAY
INCREASE INJURIES
IF THE POWER CORD IS DAMAGED, IT MUST BE REPLACED BY THE
MANUFACTURER OR
BY ITS TECHNICAL ASSISTANCE SERVICE OR IN ANY CASE BY A
PERSON WITH SIMILAR
QUALIFICATIONS, IN IN ORDER TO PREVENT ANY RISK.
ASSEMBLY
1.Front protection grid
2.Blades
3.Rear grille mounting nut
4.Rear pr otection grid
5.Motor shaft
6.Oscillation control
7.Unit body
8.Grid screw and nut
9.Blade nut
10.Base
11.Speed control
12.Counterclockwise rotation
to lock the nut
13.Clockwise rotation to loosen
the nut
14.Base screws
15.Decorative ring
1. Place the main body on the base, ensuring that holes in both components
are correctly aligned, then insert the screws and tighten.
2. Set the rear grille to the correct position on the motor shaft, with handle
facing up.
3. Firmly tighten the mounting nut of the rear grille to secure it.
4. Install the blades on the shaft until the fixing pin is fully inserted into the
blade notch.
Summary of Contents for FME000006NOC
Page 17: ...17 VENTILATOR TABELLE NOTIZIEN ...
Page 27: ...27 VENTILADOR DE MESA NOTES ...