11
TABLE FAN
5. Screw the blade nut to the motor shaft counterclockwise.
6. Use 3 screws to install the decorative ring in the center of the front grille.
7. Mount the front safety grille on the rear grille by hanging it via the top hook.
Close the latches around the grille, then mount the nut and
screw through the hole in the bottom edge of the front grille, then ti -
ghten.
INSTRUCTIONS FOR USE
Connect the plug to a suitable power outlet.
Choose the desired speed by selecting the switch as follows:
0 = Off (off)
1 = Slower speed
2 = Average speed
3 = Faster speed
OSCILLATION FUNCTION
Start the fan swing by pressing the button (6) on the top of the motor
housing and stop it by moving the button upwards (6).
MANTEINANCE
Always remove the plug from the outlet before cleaning.
Clean the fan with a soft, damp (not wet) cloth
WARNING
Do not immerse the fan in water.
Do not use cleaning chemicals such as detergents and abrasives. Do
not allow the inside to get wet as this could create a hazard.
INFORMATION FOR USERS OF DOMESTIC APPLIANCES
This marking indicates that this product should not be disposed with other
household wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To return
your used device, please use the return and collection systems or contact
the retailer where the product was purchased. They can take this product for
environmental safe recycling.
Summary of Contents for FME000006NOC
Page 17: ...17 VENTILATOR TABELLE NOTIZIEN ...
Page 27: ...27 VENTILADOR DE MESA NOTES ...
