7
JUICE EXTRATOR
INSTRUCTION MANUAL
1. Place the juicer container onto the motor base. Make sure to install the spout to
the juice outlet.
2. Install the filter into the juicer container. Make sure to press it as far as it can go.
3. Place back the top cover.
4. Lock the two safety latches on both sides of the unit.
5. After the above mentioned five steps, the unit is ready for use now. Connect it
to power source and turn on the unit. If it runs normally, you can start to make the
juicer.
6. To disassemble the unit for cleaning follow the steps in a reverse order.
1. Wash fruits & vegetables cleanly (peel skin when necessary) cut them into a pro-
per blocks or pieces. Place a juice cup or other container right under the juice outlet.
2. Connect the unit to power source and operate the control switch.
3. Place foods in the food chute and press lightly with pusher, do not use your
fingers as pusher. Extracted juice will run out from the juice outlet into the juice cup.
If the dregs container is full, Unplug and clean it out.
4. After juicing, turn the switch to “0”, then unplug it. Completely clean all parts
before you store it.
1. Do not immerse motor base, power cord or plug in water or other liquids, or per-
formance may be impaired by moisture.
2. Unplug the unit before assembly, disassembly or cleaning.
3. Do not use this unit outdoors.
4. The extractor has two operational Speed 1 is extracting soft foods such as straw-
berry, grap, pineapple, watermelon or tomato, etc. while Speed 2 is for hard foods
such as apple, carrot or pear, etc.articles as pusher.
ENG
HOW TO ASSEMBLE AND DISASSEMBLE
HOW TO USE THE JUICER EXTRACTOR
HOW TO USE THE JUICER EXTRACTOR
