Kasco marine 3400HJF, Owner'S Manual

ASSEMBLY AND INSTALLATION INSTRUCTIONS

STEP ONE 

Remove all contents from package and place on a 
clean, flat surface.  Inspect the shipment for any dam-
ages.  If damages are found, immediately notify your 
carrier and your Kasco Marine, Inc. representative.  
Next, cross reference the parts included in the ship-
ment with the Parts Included sheet in this manual on 
page 4.  Make sure you have all the parts needed.  If 
any shortages are found, contact your Kasco repre-
sentative immediately. 
 

STEP TWO 

Set Fountain Motor (Part A) upright (stainless steel 
can down) on a flat surface.  With motor housing up-
right, slide Float (Part C) over pump housing making 
sure the surface with the Kasco logo is up.   

STEP THREE 

Ensure correct alignment by twisting the float gently 
around the motor housing until the float “locks” into 
place, the bolt holes in float line up with bolt recepta-
cles on unit and power cord guide lining up with the 
cord.  See diagram below of bottom side of float. 

STEP FOUR 

With float “locked” into place, use one of the 1/4”-20 
x 3-1/4” Phillips Pan Head Screws (Part D) and a 
1/4” Flat Washer (Part E) to secure the float to the 
motor housing.  Insert screw with washer through 
bolt hole in float and into receptacle on the unit.  
Tighten until snug with a Phillips Head screw driver 
and repeat for 3 remaining screws. 

STEP FIVE 

Turn secured assembly upside down so the top of the 
float (logo side) is face down on the flat surface.  
Place Bottom Screen (Part K) onto the bottom side of 
the float.  Make sure the wide opening of the screen 
is against the float and the 3 handles on the screen do 
not interfere with the rope placements.  Using a 
stainless steel Bottom Screen Clip (Part I) , 3/8”-16 x 
1-3/8” Bolt (Part H), two 3/8” Flat Washer (Part F), 
and 3/8”-16 Nylon Lock Nut (Part G) to secure the 
screen to the float.  Align a clip so the two prongs 
straddle a wire on the screen.  Insert bolt with washer 
so the top of the bolt is facing the top of float (now in 
down position).  Place the second washer and the 
locking nut with nylon insert on the end of the bolt 
and tighten using the 9/16” Socket and Ratchet on the 
nut end and the 9/16” Wrench on the bolt end.  
Tighten until snug and repeat with remaining clip.  
(See diagrams on next page) 
 
 
 
 
 
 
 
 

5 

Logo 

Bolt Holes 

Power Cord 

Guide