2
THANKS!
We at Kasco Marine, Inc. would like to both
thank and congratulate you on your purchase
of the Low Voltage Lighting. We appreciate
you choosing Kasco and for your purchase.
Your decision to purchase Kasco’s Low Volt-
age Light will not disappoint you. Some
NEW features to Kasco’s Low Voltage Lights
are Thermal Protection from overheating and
added seal protection of the light fi xtures and
cord. We thank you for choosing Kasco for
your low voltage lighting needs and want you
to be completely satisfi ed with your purchase.
Important Safety Instructions
Please read and follow these extremely impor-
tant safety and handling instructions for your
Kasco lighting. Following these instructions
will help ensure your safety and the quality
performance of your equipment.
Always disconnect power from light be-
•
fore service or relamping.
Kasco Low Voltage Lighting must be used
•
with a 12V AC Transformer with wattage
capacity greater than the sum of all light
wattages on the circuit. (Ex. Three 75W
bulbs on the same circuit would require a
transformer of at least 225W or greater.)
Caution should be used when dealing with
•
any electrical equipment.
NEVER
•
lift or drag the light by the power
cord.
This Light is designed for submerged use
•
(see installation instructions). The internal
temperature protection will disable the light
if it is not submerged and greater than 20
watt bulb is used.
General Owner’s Instructions
INSPECT THE SHIPMENT
Immediately inspect your Kasco Low Voltage
Lighting shipment for any visible damages.
Also cross reference the Parts Included sheet
with the parts supplied to check for shortages.
Shortages should be reported immediately to
your Kasco Marine distributor or representa-
tive and damages reported to your carrier and
Kasco Marine.
CAUTION
Up to a 75W bulb can be used if the light
fi xture is submerged in water at least 1” to al-
low for proper cooling. Failure to do so could
damage the light. Do not lift the light by the
electrical cord. Always use extreme caution
around electrical equipment and water situa-
tions.
ASSEMBLY & INSTALLATION
Please see the proper Assembly and Instal-
lation Instructions enclosed in this manual.
Each is specifi c for your model Light Kit.
USE AND OPERATION
Kasco Low Voltage Lighting must be used
with the proper size 12V AC Transformer. The
wattage of this transformer must be greater
the sum wattage of all the bulbs used on that
circuit. (Ex. Three 75W bulbs on the same
circuit would require a transformer of at least
225W or greater capacity.) The wires on the
Low Voltage Lighting must be wired into the
transformer per instructions included with the
transformer. The White and Black wires on
the Low Voltage Lighting are the HOT wires.
The Green wire is the GROUND wire.
This light is designed for submerged use. The
internal temperature protection will disable the
light if it is not submerged and a greater than
