CERTISAFE™ TANK MIXER MANUAL
3
Back to Contents
Kasco offers a variety of mounting options to best position a CertiSafe™ mixer in any tank environment,
all featuring durable stainless steel. There are also several optional control panels.
These mounting kits are designed for proper placement AND retrieval of CertiSafe™ mixers.
Once installed, ONLY remove mixers via the retrieval method specific to the mount.
PM-100
Pipe Mount
The PM-100 makes use of other
structures in the tank to position
the mixer. Use the upper mount
parts above the water line to
adjust the unit’s vertical position
and to swivel the lower mount
parts and the attached mixer.
(Pre-cut stainless steel pipe not
included.)
Standard CS-100, CS-200
•
Motor contactor
•
HOA, Manual or Automatic control through
SCADA input
•
Low water automatic shutoff
•
UL 4X/3R enclosure
•
120V panel uses a 20A single pole
circuit breaker
•
240V panel uses a 30A single pole
circuit breaker
Advanced CS-150, CS-250
All standard features PLUS:
•
Ground fault protection
•
HOA, Hand and Auto position dry contacts
for SCADA
•
Mixer fault dry contact for SCADA
•
Mixer running dry contact for SCADA
•
Larger 4X/3R enclosure
Advanced models are also available in stainless
steel (CS-150SS & CS-250SS)
RM-100
Floor Mount
The RM-100 positions the
mixer stably on the tank floor
and comes with a retrieval
chain to safely lift the unit for
observation and maintenance.
Protective feet on each of the
legs are designed to prevent
any damage to the tank. (Note:
minimum clearance is 24” for
square hatches, 25” for round
hatches.)
Suspended Mount
Suspended from the tank roof,
the SM-100 uses a 60” stretcher
bar to support the mixer in a
raised position within the tank.
Two chains adjust the unit’s
elevation and facilitate safe
removal for observation and
maintenance.
The ASM-100 accessory kit
includes an additional 60”
stretcher bar.
The SM-50 Suspended Mount
includes a 30” stretcher bar.
MOUNT OPTIONS
CONTROL PANEL OPTIONS
