TEICH-AIRE MANUAL
4
ELECTRICAL
WARNING
Electrical Shock Hazard
Electrical Shock Hazard
This product must be properly grounded.
Do not modify the plug provided. If it will not fit
the outlet, have the proper outlet installed by a
qualified electrician.
If repair or replacement of the cord or plug is
necessary, do not connect the grounding wire to
either flat blade terminal. The wire with insula
-
tion that is green or green with yellow stripes is
the grounding wire.
Check the condition of the power supply wiring.
Do not permanently connect this product to wir-
ing that is not in good condition or is inadequate
for the requirements of this product.
Failure to follow these instructions can result in
fire, electrical shock, or death.
Make sure that the power supply voltage agrees with that listed on the product nameplate. All cords with
plugs must be plugged into an outlet that is properly installed and grounded in accordance with all local
codes and ordinances. Hardwired installations must be connected to a grounded, metallic, permanent
wiring system or an equipment grounding terminal or lead on the product.
It is your responsibility to contact a qualified electrician and assure that the electrical installation conforms
with all national and local codes and ordinances. The metal capacitor located on the side of the compressor
must be grounded.
Back to Contents
