Kasco LED3S19-050, Owner'S Manual

3

provide at least the same submersion to properly cool 

the ixture.  Operating the ixtures out of water will 

damage the LED and void warranty.

2. Insert the ¼” x 1-3/8” bolt into the light mounting 

bracket.  Align the bracket to the loat tab by placing 

the bolt through the light mounting hole (mounting 

bracket is on top of the loat tab) as shown in Fig. 2

Fig 2: 

3. Install the ¼” Flat Washer, ¼” Lock Washer and 

¼” Nut against the underside of the loat tab as shown 

in Fig. 3.  Tighten the nut until snug using the 7/16” 
wrench.

Fig 3

lat washer

lock washer

1/4” nut

4. Adjust the angle of the light as desired and tighten 
the ¼” x ½” bolts on the sides of the mounting bracket 
until snug.  For more uniform illumination, it is best to 

have all three ixtures at the same angle.

5. Repeat steps 1 through 4 for the remaining ixtures.  

Assembled light ixtures are pictured in Fig. 4.  Note 

the orientation of the lights and mounting brackets.

Fig 4

•  ¼” Stainless Steel Flat Washer (6)
•  ¼” Stainless Steel Nut (6)
•  ¼” x ½” Stainless Steel Bolt (12)
•  ¼” x 1” Stainless Steel Bolt (6)
•  Nylon Cable Ties (12)
•  Lower Float Brackets (6)
•  3/8” Stainless Steel Flat Washers (3)

TOOLS & SUPPLIES NEEDED
•  Two 7/16” wrenches (or one wrench & a 7/16” 

socket with driver)

•  Two 9/16” wrenches (or one wrench & a 9/16” 

socket with driver)

•  Wire Cutter (for trimming cable ties)

LED3S19 Assembly Instructions

For ease of assembly, make sure the Aerating Fountain 
is completely assembled.  Place the assembly upright.

Instructions for mounting LED3S19 on models:
2400VFX, 3400VFX, 3400HVFX, 3400JF, 3400HJF, 
4400VFX, 4400HVFX, 4400JF, 4400HJF

1. Install the mounting brackets to the light ixtures 

as shown using ¼” lock washers and ¼” x ½” bolts.  
Hand tighten only at this time.

Fig 1

Important Note:  Installation of the LED light ix

-

tures on the above listed aerating fountain units with 
the mounting brackets oriented as shown will ensure 

proper submersion of the light ixtures.  Each ixture 

must be partially submerged in order for lights to oper-

ate properly.  Other applications for these ixtures must